WMTS tech (kyklotron) TEST PROCEDURES
METHOD 2
While all other explosive detectors needs samples to be collected from the suspected material, the Device is the world’s 1st and only one system that can detect and localize the explosives from a distance. It is up to the user how effectively it can be handled and utilized for localizing the explosive area and conducting further search operations to identify and defuse the explosives to prevent the loss of life and property. Before doing any search operation the operator needs thorough knowledge of the device and also needs full-fledged training of handling the equipment. Search operation needs the fallowing steps to be fallowed:
thoMethod-2
1. Define the area of search to be conducted
2. Understand the geography of the location
3. Collect the data and furnish the profarma (Annexure-1)
4. If found more than one line scan the area from three different locations P1, P2 , P3,
P4 & P5 as shown in the Pic.2

The localization of explosive areas T1, T2 & T3 occurs when there are multiple explosives planted in the location. The localized area may be 5m to 50m radius depends upon the quantity and type of the explosives. (Note here that the magnetic field of each material/composition of the material depend on the type of material and the quantity of the material used in the explosive)
. Once the targets are localized from a long distance to be more precious/authentic about the target do the close range scanning, but keep in mind that the detection distance from the target should not be less than 50m because there is every chance for missing the target when you conduct the scan from the close range.

6. After the target is confirmed conduct the search operation with the conventional methods to trace out the Explosive.
7. Defuse the explosive
Probability of Target missing in close range detection
o Multiple explosives in the location too close to each other (less than 50m distance)

The device has integrated elements to paramagnetism the detected materials. When multiple explosives are close to each other the magnetic flux causes deviation in detection. In such case the detection is easier from a long distance than close range. Explosives, which are within 15m ranges to each other, will have to be treated as single target.
Detection of Targets on the trees and buildings

For Detection of targets on tress and buildings scanning needs to be done by deflecting the antenna above 90 degrees. Some times the close target will be overruled by the much stronger explosive dump/depot at longer distance beyond the location on search.
Very Important Note
Dos
o Works on magnetic tuned phenomenon technology
o Detects the explosives on surface within the distance up to
300m to 500m
o Detects the buried explosives up to 1m below the ground
o Detects all the pre tuned explosives
o Localizes the explosive area up to 50m radius
Don’t Dos
o Though detects explosives on the tress and building but, may
get influenced by the larger quantity of explosives beyond the
search operation area.
o Multiple explosives within the distance of 50m to each other
will have be treated as a single target and the detection done
from long distance to be should be considered.
o Only well trained operators needs to handle the device
o Don’t do the scanning while walking
o Moving target influences the detection of fixed target
You have a device on hand, which is a better alternative to the conventional existing explosive detection devices.
Use it - Don’t Abuse it
Those tests established especially for WMTS tech machines (kyklotron) by
|
C.G.R.I. Ltd |
|

Study, Design and Development of multi sensoring, microelectronic real time systems
for Safety, Defense, Counter Terrorism and Human health
Simis 15 d , Strovolos, 2044,
FAX
+302102234475,
+35722322796
E-mail :
info@cgri.gr